8
Front left
a
DC power supply out connector (2-pin)
Supplies power to an external device up to 2.5 A.
b
RET 1 (return video 1) button
The return video 1 signal from the camera control unit is
monitored on the viewfinder screen while this button is
pressed. It function the same as the RET 1 button on the
handle (
) and RET/ASSIGNABLE button A on the
operation panel on the rear of the camera (
).
You can also assign other functions to this button, using the
menu displayed on the viewfinder screen.
c
MIC 1 IN (microphone 1 input) connector (XLR 3-pin)
Connect a microphone.
This connector and the AUDIO IN CH-1 connector (
on the operation panel on the rear of the camera are
alternately activated with the CH1 audio input select switch
(
).
d
MIC (microphone) power switch
+48V:
To supply a power of +48 V to the connected
microphone.
OFF:
Not to supply a power to the connected microphone.
e
SHUTTER switch
For setting the electronic shutter functions when the camera is
used in standalone status without connecting a camera control
unit.
OFF:
The electronic shutter does not function.
ON:
The electronic shutter is activated.
SEL:
The shutter speed and shutter mode change each time
the switch is set to this position.
For details, see “Setting the Electronic Shutter” on page 16.
f
INTERCOM LEVEL control
To adjust the intercom/earphone volume level.
The intercom level adjustment is enabled when the
INTERCOM LEVEL switch (
) on the rear of the camera
is set to “FNT.”
g
RET 2 (return video 2) button
When this button is pressed, the picture on the viewfinder
screen changes to the return video signal selected using RET/
ASSIGNABLE button A, B, or C on the operation panel on the
rear of the camera or using the menu.
You can also assign other functions to this button, using the
menu displayed on the viewfinder screen.
Rear
a
CAMERA POWER switch
CCU:
Power is supplied from the camera control unit.
EXT:
Power is supplied through the DC IN connector.
b
Tally lamp and switch
ON:
The tally lamp lights when a tally signal is input to the
connected camera control unit or a call signal is
generated in response to pressing of a CALL button.
OFF:
The tally lamp is prevented from lighting.
c
RET 1/2 (return video 1/2) buttons
When pressed, the picture on the viewfinder screen changes
to the return video signal selected using the operation panel
on the rear of the camera or using the menu.
d
CCU (camera control unit) connector
HDC3100:
Connect a camera control unit using an optical
electrical multi cable.
HDC3170:
Connect a camera control unit using a triax cable.
e
SDI 1 (serial digital interface 1) connector (BNC-type)
For 3G SDI, HD SDI or HD PROMPTER signal output.
On the HDC3100, in addition to the above signals, HD TRUNK
signal input is supported.
For details on the output signals, see “Setting the Camera
Outputs” (page 19).
f
CALL button
When this button is pressed, the red tally lamp of the
RCP-1500/1000 series Remote Control Panel or the
MSU-1000-series Master Setup Unit will light. Use to call the
operator of the RCP or MSU.
a
b
c
d
f
e
g
b
c
d
e
f
a
Operation panel
(
Shoulder strap fitting
post (
)
Connector panel
(
