![background image](http://html.mh-extra.com/html/sony/hcd-m700/hcd-m700_service-manual_420803049.webp)
49
HCD-M700
4. SACD (SACD hybrid disc)
Press the 4 key on the remote commander, insert a SACD hybrid
disc, and press the ENTER “R” key on the remote commander.
The adjustment will be made through the following steps, then the
adjusted values will be stored in the EEPRM. However, if the SACD
hybrid disc is not available yet, please use your player in the initial
data so that do not make this adjustment. Press the DVD
x
“R”
key to exit the adjustment.
SACD Disc Adjustment Steps
1.
Sled Tilt Reset
2.
Set Disc Type CD
3.
LD ON
4.
Spdl Start
5.
Wait 500 msec
6.
Focus Servo ON 0
7.
Auto Trck Offset Adjust
8.
No Adjustment
9.
CLVA ON
10.
Wait 500 msec
11.
tracking ON
12.
Wait 1 sec
13.
Sled ON
14.
Check CLV ON
15.
Auto LFO Adjust
16.
Auto Focus Offset Adjust
17.
No Adjustment
18.
Auto Focus Gain Adjust
19.
Auto Focus Offset Adjust
20.
Eq Boos Adjust
21.
Auto LFO Adjust
22.
Auto Track Gain Adjust
23.
32Tj Fwd
24.
32Tj Rev
25.
500Tj Fwd
26.
500Tj Rev
27. All Servo Stop
Drive Manual Operation
On the Test Mode Menu screen, Press the 2 key on the remote
commander, and the manual operation menu will be displayed. For
the manual operation, each servo on/off control and adjustment can
be executed manually.
## Drive Manual Operation ##
Operation Menu
1. Disc Type
2. Servo Control
3. Track/Layer Jump
4. Manual Adjustment
5. Auto Adjustment
6. Memory Check
7. Sacd Water Mark
0. Disc Check Memory
_
Exit: Return
In using the manual operation menu, take care of the following your
points. These commands are not protected, thus requiring your
correct operation. The sector address or time code field is displayed
when a disc is loaded.
1. Set correctly the disc type to be used on the Disc Type screen.
The disc type must be set after a disc was loaded.
The set disc type is cleared when the tray is opened.
2. After power ON, if the Drive Manual Operation was selected,
first perform “Reset SLED TILT” by opening 1. Disc Type
screen.
3. In case of an alarm, immediately press the DVD
x
“R” key
on the remote commander to stop the servo operation, and turn
the power OFF.
Basic operation (
?/1
and DVD
x
are controllable from front
panel or remote commander)
?/1
Power OFF
DVD
x
Servo stop
Z
Stop+Eject/Loading
RETURN “R”
Return to Operation Menu or Test Mode
Menu
DVD
>
“R”
, DVD
.
“R” Transition between sub modes of menu
1 “R” to 9 “R” , 0 “R” Selection of menu items
v
“R”
,
V
“R”
Increase/Decrease in manually adjusted
value
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299