Sony Handycam Vision CCD-TRV300E, Service Manual

Page: 134 / 167

5-52
3. BPF f0 Adjustment (VC-195 board)
Sets the BPF passing frequency so that the AFM signal can separate
from the playback RF signal properly. If deviated. the mono/stereo
mode will be differentiated incorrectly, and noises and distortions
will increase during high volume playback.
Mode Playback
Signal Alignment tape:
For BPF adjustment
(WR5-11CS)
Measurement Point Audio output terminal left or right
Measuring Instrument distortion meter
Adjustment Page F
Adjustment Address 47
Specified Value The Main and Sub channel distortion
rate should be almost the same
(within
±
1%) and minimum.
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Set the Hi-Fi sound switch (menu display) to “2”.
3) Select page: F, address: 47, change the data and minimize the
distortion rate.
4) Press the PAUSE button of the adjusting remote commander.
5) Set the Hi-Fi sound switch (menu display) to “1”.
6) Select page: F, address: 47, change the data and minimize the
distortion rate.
7) Press the PAUSE button of the adjusting remote commander.
8) Repeat steps 2) to 7) and set the data of address: 47 so that the
distortions rates when the Hi-Fi sound switch is set to “2” and
set to “1” respectively are almost the same and minimum.
9) Press the PAUSE button of the adjusting remote commander.
11) Select page: 0, address: 01, and set data: 00.
12) Set the Hi-Fi sound switch to “STEREO”.