1
Basic Functions
FCB-EH6300(GB) A-E23-100-13(1)
Threshold values
• You can set the threshold value that determines high
or low intensity.
• The minimum threshold value is 1h (decimal: 1), and
the maximum threshold value is FE1h (decimal:
4065).
• The default setting for the threshold value is 200h
(decimal: 512).
Grayscale image
(256 levels)
Color image
Binarization
process
Assign any
color
Temperature Reading Function
The conversion value (hex) of the temperature sensor
built into to the camera can be read by using a query
command. The conversion value has an error of ±3 C,
and because the temperature sensor is inside the
camera, this value is not the ambient temperature. Use
it as a reference value.
StableZoom™
StableZoom is a function for performing correction
using the Image Stabilizer function in accordance with
the zoom ratio, and smoothly zooming up to
approximately ×36 using a combination of the optical
zoom and digital zoom. The digital zoom can be
further used to zoom up to ×360. At the wide end, you
can obtain images without any reduction in the angle
of view and resolution because the digital zoom is not
switched ON. On the other hand, at the Tele end, the
correction effect by the Image Stabilizer function is at
its maximum so blurring is reduced. The StableZoom
function can be switched ON/OFF in the register
settings.
Blurring is corrected in this
digital zoom area.
x360
approx.
x36
x30
Zoom
ratio
Wide
Optical zoom position
Tele
Angle of view and resolution
Optical zoom
Digital zoom
StableZoom
The digital
zoom is not
switched ON
at the wide
end.
Image Stabilizer
Switching ON the Image Stabilizer function reduces
image blurring caused by, for example, vibration, which
allows you to obtain images without much blurring. A
correction effect of approximately 90% is possible for a
vibration frequency of around 10 Hz. The Image
Stabilizer function employs the digital zoom system, so
the angle of view and resolution are changed, but the
sensitivity is maintained.
Hold Function of Image Stabilizer
With the Image Stabilizer function, suddenly stopping
high-speed movement (pan, tilt, etc.) of the camera
produces a blur sensor counteraction that may cause
image movement. In such a case, you can use a
command setting (hold) to maintain the correction of
the Image Stabilizer function. In this case the image
stabilizer is off, but there is no change in the angle of
view.
Notes
•
When image stabilizer is activated, residual movement may
appear on the top and bottom of the image.
•
The hand shake correction function may not work correctly
under the condition that high-frequency vibration component
exits. In such a case, set the hand shake correction function to
OFF.
Summary of Contents for FCBEH6500
