Sony FCB-CH7500, Operation Manual, Page: 10 / 51

10
Due to each camera from factory, all the ID address are the same,so if before install Ip camera, you can use ONVIF Discovery Tool to configuration IP
address. Use mouse to choose the device,input the device ONVIF protocol’s user name and password, double-click will pop-up current device’s
information dialog box, can configurable IP address..etc.After modify, click”SAVE”, it will show you a tip to tell you are succeed, then click”Reboot” to
re-start the device.
Test whether connected
After setup IP address, click left bottom of PC: Start--all program--attachment”,open”Command Prompt”,use PING command to test whether PC has
connected with IP camera.
Command as: Ping 192.168.1.8
If screen show“Request timed out.”or” destination host unreachable”,it means install not OK.Please check below:

Hardware connect correct or not
 PC’s TCP/IP set Full-Mesh as IP camera or not.

Whether network forbid PING command or not,please ask network manager.
2.2 Log in the network