SEL1855 (E 18-55mm F3.5-5.6 OSS)
4-5
8) The screen shown in Fig.4-3-9 appears when the adjustment is complete.
9) Click the [
°
] button on the upper right of the pop-up window.
* The “FINISHED” dialog box will appear when click the [
°
] button.
4) Once turn the zoom to WIDE end.
5) Turn the zoom ring towards the TELE direction until the adjustment value displayed on the lower left of the window runs into the allowable range
of the setting value (hexadecimal numeral) shown in [ ].
* The bar and value (hexadecimal numeral) under the window are displayed by interlocking with the behavior of the zoom ring.
* A green line is displayed on the bar under the window as a reference of the setting value.
* The allowable range of the setting value is ±2.
* When the adjustment value displayed on the lower left of the window runs into the allowable range of setting value, the background of it will turn blue.
NOTE:
When operating the zoom ring, operate slowly not to make the adjustment value displayed on the lower left of the window run out of the + side of setting
value allowable range.
Error will occur even if the adjustment value that has ran out of the + side of setting value allowable range is returned in the allowable range.
6) Press the ENTER key.
7) Repeat the operations from steps 4) to 6) to “POS8”.
Fig.4-3-7
Fig.4-3-8
Fig.4-3-9
4-4. IMAGE QUALITY CHECK/ADJUSTMENT
4-4-1. Adjusting Procedure
Check/Adjusting Procedure
Note1:
If the result of the projective resolving power (partial blur) check is NG, replace the 1 Group Block Assy.
* If it cannot be resolved even after replacing the 1 Group Block Assy, replace the Service Exclusive Optics Block.
Note2:
If the result of the flange back check (after adjustment) is NG, replace the parts in the order shown below.
1. Zoom Cam Barrel
2. 1 Group Block Assy
* If it cannot be resolved even after replacing the parts 1) and 2), replace the Service Exclusive Optics Block.
Check the
resolving power (partial blur)
section 4-5-2
OK
OK
NG
NG
Adjust the flange back
OK
NG
NG
OK
Image Quality
END
Partial blur
Focus
Replace the Lens (Note2)
Replace the Lens (Note1)
resolving power (partial blur)
Check the
resolving power (partial blur)
section 4-5-2
