35
Setting menus
LOCK:
The power switch is locked.
When LOCK is selected, the power switch
lock icon appears in the display.
Wireless remote control
function
(RF REMOTE)
This function must be set to allow the
wireless remote control function to be used
between the transmitter and receiver.
OFF:
Stops the wireless remote control
function.
ON:
Starts the wireless remote control
function with the previously paired
receiver.
PAIRING:
Executes a new pairing.
For details, see “Pairing with a receiver” on
page 26.
Setting the brightness of
the display
(BRIGHTNESS)
Ten levels of brightness can be selected for
the organic light-emitting diode display.
The selectable settings are the following:
(Dark)
1 2 3 4 5 6 7 8 9 10
(Bright)
Automatic dimming of the
display
(DIMMER MODE)
The organic light-emitting diode display
can be set to dim or turn off after a certain
amount of time.
AUTO OFF:
The display turns off after 30
seconds. The display goes on again when
you press the SET, +, or – button.
AUTO DIMMER:
The display dims after
30 seconds. The display becomes bright
again when you press the SET, +, or –
button.
ALWAYS ON:
The display stays on at the
brightness level set with the BRIGHTNESS
function.
Resetting parameters to
their factory settings
(FACTORY PRESET)
All parameter settings can be returned to
their factory settings.
Holding down the SET button until a
message appears asking for confirmation.
Press the + or – button repeatedly to select
YES, and then press the SET button to
enter. The transmitter parameters are reset
to their factory settings.
The setting for this function cannot be
changed during actual signal transmission.
To change the setting, turn off the power
first. Then while holding down the SET
button, turn the power on. Then change the
setting after the signal transmission has
stopped.
Displaying the software
version
(VERSION)
The version of the transmitter software can
be displayed.
Note
