16
Using the Cross Remote
carried out. After setting the microphone
ready for pairing in step
5
above, be sure
to close the grip.
To use the Cross Remote with
a previous pairing
In the RF REMOTE indication, select ON.
• When you set RF REMOTE to ON, the
microphone will communicate with the
receiver to which it was previously
paired. To use the wireless remote
control function with another receiver,
you must perform the pairing procedure
for that receiver.
• Multiple microphones/transmitters
cannot be paired with the same receiver.
• If you reset all parameters by using the
FACTORY PRESET function
, the pairing setting of the microphone
is also cleared.
The following microphone settings
can be done from the remote control:
• Microphone name setting
• Frequency band/group/channel selection
• RF transmission power setting
• Attenuator for the audio input setting
• Low-cut filter setting
• Power save setting
• Resetting accumulated use time
• Internal signal setting
• POWER switch lock setting
For details on menu operation, see “Setting Menus”
on page 21.
To perform remote control, the receiver must be
equipped with a control function for the setting you
want to control. For details, refer to the operating
instructions supplied with the receiver.
To cancel the Cross Remote
In the RF REMOTE indication, select OFF.
Notes on the Cross Remote
The wireless remote control function on the
microphone uses the 2.4-GHz band and
may thus be subject to interference from
other devices.
• When pairing fails (“Pairing fail” is
displayed), successful communication
between the microphone and the receiver
has not occurred within a given amount
of time. Pairing may be harder to do
when another receiver is engaged in
pairing nearby.
• When it becomes hard to use the remote
control, the remote control may be
improved by switching the wireless
remote control function off, then on again
in the RF REMOTE display, then re-
pairing with the microphone (change to a
channel with less interference).
Notes