2-7
DSC-WX1_L2
2-4. ZOOM GEAR BLOCK REPLACING METHOD
Removal
1
Remove one screw.
2
Remove the Zoom Gear Block upward.
3
Remove the Naruto Gear.
4
Remove the Z Tape.
Note:
The Z Tape is not supplied. Please reuse.
5
Disengage two claws
A
and
B
in this order to remove the FG Plate Spring.
Note:
The FG Plate Spring cannot be reused.
6
Remove two sensors on the lens flexible board.
7
Break two solders, and remove the lens flexible board.
Installation
1
Confirm the direction of Zoom Gear Block, and install the lens flexible board with two solders.
2
Install two sensors of Zoom Gear Block.
3
Engage two claws
A
and
B
in this order to install FG Plate Spring.
4
Stick the Z Tape.
5
Install Naruto Gear (S).
6
With four bosses fitted in position, install Zoom Gear Block.
7
Tighten one screw.
*
Tightening torque = 0.068
±
0.01N
•
m (0.7
±
0.1kgf
•
cm)
Screw
Zoom Gear Block
Zoom Gear Block
Front Side
Rear Side
FG Plate Spring
Z Tape
Sensors
Solders
Naruto Gear
Claw
A
Claw
B
Zoom Gear Block
FG Plate Spring
Z Tape
Sensors
Solders
Claw
B
Claw
A
Screw
Zoom Gear Block
Naruto Gear
Bosses
Bosses
