62
To change the insert end point
Press ZERO SET MEMORY again after step 5 to erase the ZERO SET MEMORY
indicator and begin from step 3.
Notes
•The zero set memory function works only for tapes recorded in the Digital8 system.
•The picture and sound recorded on the section between the insert start and end points
will be erased when you insert the new scene.
When the inserted picture is played back
The picture may be distorted at the end of the inserted section. This is not a
malfunction.
To insert a scene without setting the insert end point
Skip step 3 and 4. Press
x
when you want to stop inserting.
Inserting a scene from a VCR – Insert Editing
(
1
)
Set the POWER switch to VTR.
(
2
)
On the VCR, locate just before the insert start point
[
a
]
, then press
X
to set the VCR
to the playback pause mode.
(
3
)
On your camcorder, locate the insert end point
[
c
]
by pressing
m
or
M
. Then
press
X
to set it to the playback pause mode.
(
4
)
Press ZERO SET MEMORY on the Remote Commander. The ZERO SET MEMORY
indicator flashes and the end point of the insert is stored in memory.
(
5
)
On your camcorder, locate the insert start point
[
b
]
by pressing
m
, then press
z
REC and the button on its right simultaneously to set your camcorder to the
recording pause mode.
(
6
)
First press
X
on the VCR, and after a few seconds press
X
on your camcorder to
start inserting the new scene.
Inserting automatically stops near the zero point on the counter. Your camcorder
automatically stops. The end point
[
c
]
of the insert stored in memory is canceled.
4
0:00:00
ZERO SET
MEMORY
ZERO SET
MEMORY
5
REC
Summary of Contents for Digital 8 DCR-TRV120
Page 131: ......
Page 132: ...Sony Corporation Printed in Japan ...
