64
GB
Tape Deck
The tape does not record.
• The tab has been removed from the cassette (see
“To save a tape permanently” on page 66).
• The tape has reeled to the end.
The tape does not record nor play, or there is
a decrease in sound level.
• The heads are dirty (see “Cleaning the tape heads”
• The record/playback heads are magnetized (see
“Demagnetizing the tape heads” on page 66).
The tape does not erase completely.
• The record/playback heads are magnetized (see
“Demagnetizing the tape heads” on page 66).
There is excessive wow or flutter, or the sound
drops out.
• The capstans or pinch rollers are dirty (see
“Cleaning the tape heads” on page 66).
Noise increases, or the high frequencies are
erased.
• The record/playback heads are magnetized (see
“Demagnetizing the tape heads” on page 66).
After pressing
hH
or
Z
, there is a
mechanical noise, “EJECT” appears in the
display, and the unit enters standby mode
automatically.
• The cassette tape is not inserted correctly.
Tuner
There is severe hum or noise (“TUNED” or
“STEREO” flashes in the display).
• Adjust the antenna.
• The signal is too weak. Connect an external
antenna.
• Set “DVD POWER OFF” by DVD power manage
function (page 41).
A stereo FM program cannot be received in
stereo.
• Press REPEAT/FM MODE on the remote so that
“MONO” disappears.
If other troubles not described
above occur, reset the system as
follows:
Use buttons on the unit for the operation.
1
Press
x
, DISPLAY and GROOVE at the
same time.
2
Unplug the power cord.
3
Plug the power cord back in.
4
Press
?/1
to turn on the power.
The system is reset to the factory settings except
for DVD settings. You should set the settings
you made, such as the preset stations, clock, and
timer.
To reset the DVD settings, select “RESET” in
step 2 of “Using the Setup Display” (page 25).
After you select “RESET” and press ENTER on
the remote, select “YES”, then press ENTER on
the remote to reset the settings (it takes a few
seconds to complete). Do not press
?/1
when
resetting the system.
