Sony DCR-PC110E, Service Manual, Page: 7 / 187

— 7 —
: Unloading
: Loading
Loading motor
VC-253 board
DC power supply
(+4.5Vdc)
AI-021 board
Disconnect from CN256
AI-021 board
SERVICE NOTE
1. POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4V), the power is shut off so
that the unit cannot operate.
This following two methods are available to prevent this. Take note of which to use during repairs.
Method 1.
Use the AC power adaptor (AC-L10, AC-VQ800 etc.).
Method 2.
Connect the servicing remote commander RM-95 (J-6082-053-B) to the LANC jack, and set the commander switch to the “ADJ” side.
2. HOW TO OPEN THE FLASH WHEN THE FLASH DOESN’T OPEN
3. TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
1
Refer to 2-2. to remove the jack ornamental plate.
2 Refer to 2-2. to remove the upper cabinet .
3
Refer to “2. HOW TO OPEN THE FLASH WHEN THE FLASH
DOESN’T OPEN” to open the flash.
4
Refer to 2-2. to remove the cabinet (L) assembly.
5 Refer to 2-2. to remove the microphone unit.
6 Refer to 2-3. to remove the EVF block.
7
Refer to 2-4. to remove the cabinet (R) assembly.
8
Refer to 2-7. to remove the IR window.
9
Refer to 2-7. to remove the MF ring.
0 Refer to 2-7. to remove the lens block.
qa
Disconnect CN256 (27P) of VC-253 board.
qs
4.5V from the DC power supply to the loading motor
and unload with a pressing the cassette compartment.
A
B
3
Cabinet (upper)
6
Open the flash unit.
Lock plate
5
Push the lock plate in the
direction of the arrow
B
to open the flash unit.
4
Move the microphone block
in the direction of the arrow
A
.
1
Screw
(M1.7
×
4),
lock ace, p2
2
Two claws