Sony DAV-DZ340, Operating Instructions Manual

Page: 58 / 72

58
GB
Sound
Playback picture becomes
distorted. • Set [YC
B
C
R
] in [YC
B
C
R
/RGB (HDMI)] to [RGB] (page 51).
Symptom Problems and solutions
There is no sound. • The speaker cord is not connected securely.
• Check the speaker settings (page 53).
There is no sound when the
component (digital satellite
receiver, PlayStation 3, etc.) is
connected directly to your TV
via HDMI. • Perform the following:
– Connect the system and TV with a SCART (EURO AV) cable (page 21) and
select the “TV” function.
– Disable your TV’s speakers.
There is no sound from the
DIGITAL IN OPTICAL jack. • The sampling frequency of the input stream is more than 48 kHz.
There is no digital sound from
the HDMI OUT jack when using
the Audio Return Channel
function. • Set [AUDIO RETURN CHANNEL] in [HDMI SETUP] to [AUTO] (page 51).
• Set [CONTROL FOR HDMI] in [HDMI SETUP] to [ON] (page 51).
• Make sure that your TV is compatible with the Audio Return Channel function.
• Make sure that an HDMI cable is connected to a jack on your TV that is
compatible with the Audio Return Channel function.
• The sampling frequency of the input stream is more than 48 kHz.
The system does not output
sound correctly when connected
to a set-top box. • Set [AUDIO RETURN CHANNEL] in [HDMI SETUP] to [OFF] (page 51).
Severe hum or noise is heard. • Move your TV away from the audio components.
• Clean the disc.
The sound loses stereo effect
when you play a VIDEO CD, a
CD, or an audio file. • Select stereo sound by pressing AUDIO (page 32).
There is no sound or the volume
level is very low from a certain
speaker or all the speakers. • Check the sound mode (page 41).
• Check the speaker connections and settings (pages 20, 53).
• Depending on the DVD, the output signal may not be the entire 5.1 channel.
The sound comes from the center
speaker only. • Depending on the disc, the sound may come from the center speaker only.
There is no system sound from
your TV. • Set [AUDIO (HDMI)] in [HDMI SETUP] to [ON] (page 51).
• Perform the following procedure:
1
Turn the system off and on again.
2
Turn the connected component off and on again.
3
Disconnect and then connect the HDMI cable again.
The sound of files played from a
DATA CD/DATA DVD/USB
device is distorted. • The bit rate used when encoding the audio files was low. Transfer audio files
encoded with higher bit rates onto the DATA CD/DATA DVD/USB device.
There is noise or the sound skips
while playing a USB device. • Copy the files to your computer, format the USB device in FAT12, FAT16, or
FAT32 format, and transfer the files to the USB device again.
Symptom Problems and solutions