Sony CPD-110GS, Service Manual

Page: 13 / 40

CPD-110GS/110EST
3
When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in
the direction of the arrow
c
.
• HOW TO HANDLE AN ANODE-CAP
1
Don’t hurt the surface of anode-caps with shartp shaped material!
2
Don’t press the rubber hardly not to hurt inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
3
Don’t turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or hurt the rubber.
a
b
Anode Button
c
• REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT,
after removing the anode.
• REMOVING PROCEDURES
1
Turn up one side of the rubber cap in
the direction indicated by the arrow
a
.
2
Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow
b
.
2-4. PICTURE TUBE REMOVAL
2-2
Demagnetic coil
12
13
Tension spring
2 A board
GND
GND
CN506
GND
GND
CN308
CN307
Two
degaussing
coil holders
14
CN501
CN603
Two screws
(+BVTP 4 x 16)
5
Stand assy
4
3 Claw
Bottom cover
(D board)
7
6 Claw
Cushion
Two degaussing
coil holders 15
1 Anode cap
Picture tube 11
Deflection yoke
9
Neck assy 8
Four screws
(Tapping screw 5)
10
Connector
(2pin)