Tuner
15
GB
To select a desired preset number
using the number buttons on the
remote
Press number buttons instead of performing
step 3.
To enter preset number 10 or higher, press >10
and enter the corresponding digits. To enter 0,
press 10/0 instead.
Example:
To enter preset number 20, press >10, then 2 and
10/0.
Listening to a non-preset
radio station
— Manual Tuning
1
Press TUNER/BAND (or TUNER BAND
on the remote) repeatedly to select
“FM” or “AM”.
2
Press TUNING MODE on the remote
repeatedly until “MANUAL” appears.
3
Press TUNING – or + (or – or + on the
remote) repeatedly to tune in the
desired station.
Tips
• To improve the broadcast reception, adjust the
supplied antennas, or connect a commercially
available external antenna.
• When an FM stereo program has static noise, press
FM MODE on the remote repeatedly until
“MONO” appears. There will be no stereo effect,
but the reception will improve.
• Press TUNING MODE on the remote repeatedly
until “AUTO” appears in step 2, then press
TUNING – or + (or – or + on the remote). The
frequency indication changes and the scanning
stops when the system tunes in a station (Automatic
Tuning).
To change the AM tuning interval
(except for the European model)
The AM tuning interval is factory-preset to 9 kHz
(10 kHz for some areas). To change the AM tuning
interval, tune in any AM station first, then turn off the
system. While holding down FUNCTION on the
system, turn the system back on. When you change
the interval, all the AM preset stations are erased. To
reset the interval, repeat the same procedure.
Tips
• The preset stations are retained for about a day even
if you disconnect the power cord or if a power
failure occurs.
• You can label the preset stations (see page 16).
• To improve the broadcast reception, adjust the
supplied antennas, or connect a commercially
available external antenna.
Listening to the radio
You can listen to a radio station either by
selecting a preset station or by manually tuning
in a station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 13).
1
Press TUNER/BAND (or TUNER BAND
on the remote) repeatedly to select
“FM” or “AM”.
2
Press TUNING MODE on the remote
repeatedly until “PRESET” appears.
3
Press TUNING – or + (or – or + on the
remote) repeatedly to select the desired
preset station (or station name
*
or RDS
station name
**
).
* The station name appears only if you have
labeled the station (see “Labeling the preset
stations” on page 16).
** European model only.
