CMT-DH7BT.GB.3-097-195-11(2)
GB
Pairing this system with Bluetooth
headphones
Pairing is an operation where Bluetooth
devices register with each other
beforehand. Use the procedure below
to pair the system with your Bluetooth
headphones. Once a pairing operation
is performed, it does not need to be
performed again. If pairing is already
completed, proceed to “Playing music on
this system” (page 57).
1
Select a function other than the
Bluetooth function.
Press FU/
repeatedly.
2
Place the Bluetooth
headphones to be connected
to this system within 1 meter of
the system.
3
Put the Bluetooth headphones
in pairing mode.
For details about the operations of the
Bluetooth headphones, refer to the
operation manual supplied with your
Bluetooth headphones.
4
Press and hold BLUETOOTH
OPR
on the unit for about 7
seconds until the BLUETOOTH
indicator
flashes.
Sound output from the speakers is
stopped.
5
Enter the passcode.
Follow the same procedure as in
step 4 of “Pairing this system with a
Bluetooth device” (page 53).
Once pairing is completed and the
connection is established, the system
display changes as follows:
“Connect”
Name of the Bluetooth
device
To cancel passcode entry partway
Press
.
Notes
“Passcode” may be called “Passkey,” “PIN
code,” “PIN number” or “Password,” etc.
depending on the device.
This system only supports numerical
passcodes up to 4 digits.
The pairing standby status of the system is
cancelled after about 30 seconds. If pairing
is not successful, redo the procedure from
step 1.
While connected to a Bluetooth device, this
system cannot be detected and a connection
cannot be established from another
Bluetooth device.
Pairing may not be possible if other
Bluetooth devices are present around the
system. In this case, turn off the other
Bluetooth devices.
To erase all the pairing registration
information
1
Press FU/
repeatedly
to select “BLUETOOTH” (or press
BLUETOOTH
on the unit).
When the system is connected with a
Bluetooth device (when the Bluetooth
device name or other information
appears in the system display), press
and hold BLUETOOTH OPR
on
the unit for about 2 seconds to put the
system in Bluetooth standby mode.
2
Press CLEAR
.
“Delete?” appears.
3
Press ENTER
.
“Complete!” appears and all the
pairing information is erased.
Note
To connect with Bluetooth headphones after
performing this operation, you must enter the
passcode again.
Summary of Contents for CMT-DH7BT - Micro Hi Fi Component System
Page 91: ...Additional Information 91GB ...
Page 92: ...Printed in China ...
