T
rou
b
les
hooti
n
g
29
GB
Tuner
Severe hum or noise/stations cannot be
received.
• Set the proper band and frequency (page 12).
• Connect the antenna properly (page 6).
• Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend you
connect a commercially available external
antenna.
• The supplied FM lead antenna receives signals
along its entire length, so make sure you extend it
fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Consult your nearest Sony dealer if the supplied
AM antenna has come off the plastic stand.
• Try turning off surrounding electrical equipment.
• Set “CD POWER OFF” by CD power manage
function (page 13).
A stereo FM program cannot be received in
stereo.
• Press FM MODE until “MONO” disappears.
Tape deck
After pressing
nN
, there is a mechanical
noise, “Eject” appears in the display, and the
unit enters standby mode automatically.
• Insert the cassette correctly.
The tape does not record or play, or there is a
decrease in sound level.
• The heads are dirty. Clean them (page 32).
• The record/playback heads are magnetized.
Demagnetize them (page 32).
The tape does not erase completely.
• The record/playback heads are magnetized.
Demagnetize them (page 32).
There is excessive wow or flutter, or the sound
drops out.
• The capstans in the tape deck are dirty. Clean
Noise increases or the high frequencies are
erased.
• The record/playback heads are magnetized.
Demagnetize them (page 32).
The tape does not record.
• No cassette is loaded. Load a cassette.
• The tab has been removed from the cassette.
Cover the broken tab with adhesive tape
(page 32).
• The tape has wound to the end.
Optional components
There is no sound.
• Refer to General item “The clock setting/radio
presetting/timer is canceled.” (page 27) and check
the condition of the system.
• Connect the component properly (page 25) while
checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions supplied with
the connected component and start playing.
• Press FUNCTION repeatedly to select “MD” or
“VIDEO” (page 26).
The sound is distorted.
• Set the volume of the connected component
lower.
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
1
Disconnect the power cord.
2
Reconnect the power cord.
3
Press
?/1
to turn on the system.
4
Press
x
, DIMMER and
?/1
on the unit.
The system is reset to the factory settings. You
should set the settings you made, such as the
preset stations, clock, and timer.