![background image](http://html.mh-extra.com/html/sony/cmt-cp33md-micro-hi-fi-component-system/cmt-cp33md-micro-hi-fi-component-system_operating-instructions-manual_420292008.webp)
8
Step 3: Presetting radio stations
(continued)
To stop scanning
Press TUNING MODE.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until “AUTO”
and “PRESET” disappear from the display in
step 2, then press or – repeatedly to
tune in the station manually.
To set another station to the
exist preset number
Start over from step 1. After step 5, press
.
or
>
on the remote to select the preset number on
which you want to store the station.
To erase a preset station
1
Press MENU/NO on the remote.
2
Press
.
or
>
repeatedly until “P.Erase ?”
appears.
Select “P.All Erase ?” when you want to erase
all the preset stations.
3
Press ENTER/YES on the remote.
4
Press
.
or
>
repeatedly to select the
preset number you want to erase.
5
Press ENTER/YES.
“Complete !!” appears.
When you erase a preset number, the preset
number decreases by one and all preset numbers
following the erased one are renumbered.
To change the AM tuning
interval (except for the European
model)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the system. While holding down the TAPE
x
button, turn the system back on. When you change
the interval, all the AM preset stations are erased.
To reset the interval, repeat the same procedure.
Tips
• The preset stations are retained for about a day even
if you disconnect the power cord or if a power
failure occurs.
• You can label the preset stations (see page 63).
• When an FM stereo program has static noise, press
STEREO/MONO until “MONO” scrolls in the
display. There will be no stereo effect, but the
reception will improve. Press the button again to
restore the stereo effect.