Sony CAM-90, Installation Manual

Page: 7 / 20

15
Digital Day&Night Color Camera
14
Digital Day&Night Color Camera
Installation
3. Please remove the cover of the auto iris lens connection plug and solder
the lens cable to the connector pin in the plug.
4. Please replace the auto iris lens connection plug cover and take off the
lens protection cap, and then attach the auto iris lens to the camera by
screwing it in clockwise.
5. Please insert the connection plug that is connected to the auto iris lens
cable into the auto lens connector, which is located on the back of the
camera.
6. Please set the lens selection switch, located on
the back of the camera, to DC or VIDEO
depending on the type of auto iris lens which is
being used.
Pin No.
LENS
DC VIDEO
No.1 Pin Damping- Red(power)
No.2 Pin NC
No.3 Pin Drive+ White)video signal)
No.4 Pin Dreve- Black(GND)
Lenses are sold separately. Lenses such as auto iris lens,
CS-Mount lens and C-Mount lens can be used.
1. Please peel off about 8mm of the outer skin of the auto iris lens cable.
2. Please peel off about 2mm of the outer skin of the insulated conductor
inside the lens cable.
Menu
Note
• Use of the DC auto iris lens is recommended to achieve the best
results for operating this product effectively.
• Please keep the lens clean.
Any foreign objects and fingermarks on the lens can cause inferior
• image quality in low light level conditions.
When using an auto iris lens
Installation