11
GB
Start-up G
u
ide
6
Press
F
/
f
to select “Antenna” or “Cable”,
then press
.
If you select “Cable”, the screen for
selecting the scan type appears. See “To
tune the unit for Cable connection”
(page 11).
The unit starts searching for all available
digital channels, followed by all available
analogue channels. This may take some
time, so do not press any buttons on the
unit or remote while proceeding.
If a message appears for you to confirm
the aerial connection
No digital or analogue channels were
found. Check all the aerial/cable
connection and then press
to start auto-
tuning again.
7
When the “Programme Sorting” menu
appears on the screen, follow the steps of
“Programme Sorting” (page 37).
If you do not change the order in which
the analogue channels are stored on the
unit, press
RETURN
to go to step 8.
8
For details, see page 33.
9
For details, see page 31.
10
Press .
The unit has now tuned in all the available
channels.
~
• When a digital broadcast channel cannot be
received, or when selecting a country in which
there are no digital broadcasts in step 3, the time
must be set after performing step 7.
To tune the unit for Cable connection
1
Press .
2
Press
F
/
f
to select “Quick Scan” or “Full
Scan”, then press .
“Quick Scan” :
channels are tuned
according to the cable operator
information within the broadcast signal.
Recommended setting for “Frequency”,
“Network ID” and “Symbol Rate” is
“Auto.”
This option is recommended for fast
tuning when supported by your cable
operator.
If the “Quick Scan” does not tune, please
use the “Full Scan” method below.
“Full Scan” :
All available channels are
tuned and stored. This procedure may take
some time.
This option is recommended when “Quick
Scan” is not supported by your cable
provider.
For further information about supported
cable providers, refer to support web site:
http://support.sony-europe.com/TV/
DVBC/
3
Press
f
to select “Start”, then press .
The unit starts searching for channels. Do
not press any buttons on the unit or
remote.
~
• Some cable providers do not support “Quick
Scan.” If no channels are detected using “Quick
Scan”, perform “Full Scan.”
Auto Tunin
g
OK
Cancel
Do you want to
s
tart Auto Tunin
g
?
Quick
S
tart
Ye
s
No
Do you want to enable Quick
S
tart?
TV turn
s
on more quickly but
s
tandby power
con
s
umption i
s
increa
s
ed.
Control for HDMI
Yes
No
Do you want to enable control for compatible
HDMI devices
?
Choosing "Yes" will increase
standby power consumption.
