6
GB
4
Press
F
/
f
to select the country/region in
which you will operate the TV, then press
.
If the country/region in which you want to use the
TV does not appear in the list, select “-” instead of
a country/region.
7: Auto-tuning the TV
1
Before you start auto-tuning the TV, insert
a pre-recorded tape into the VCR
connected to the TV (page 4) and start play
back.
The video channel will be located and stored on
the TV during auto-tuning.
If no VCR is connected to the TV, skip this step.
2
Press .
3
Press
F
/
f
to select “Antenna” or “Cable”,
then press
.
If you select “Cable”, the screen for selecting the
scan type appears. See “To tune the TV for Cable
connection” (page 6).
The TV starts searching for all available digital
channels, followed by all available analogue
channels. This may take some time, so do not
press any buttons on the TV or remote while
proceeding.
If a message appears for you to confirm the aerial
connection
No digital or analogue channels were found.
Check all the aerial/cable connection and then
press
to start auto-tuning again.
4
When the Programme Sorting menu
appears on the screen, follow the steps of
“Programme Sorting”(page 26).
If you do not change the order in which the
analogue channels are stored on the TV, go to
step 5.
5
Press MENU to exit.
The TV has now tuned in all the available
channels.
~
When a digital broadcast channel cannot be received, or
when selecting a region in which there are no digital
broadcasts in step 4 (page 6), the time must be set after
performing step 5.
To tune the TV for Cable connection
1
press
.
2
Press
F
/
f
to select “Quick Scan” or “Full
Scan”, then press
.
"Quick Scan" : channels are tuned according to
the cable operator information within the
broadcast signal.
Recommended setting for "Frequency", "Network
ID" and "Symbol Rate" is "Auto".
This option is recommended for fast tuning when
supported by your cable operator.
If the "Quick Scan" does not tune, please use the
"Full Scan" method below.
"Full Scan" : All available channels are tuned
and stored. This procedure may take some time.
This option is recommended when "Quick Scan"
is not supported by your cable provider.
For further information about supported cable
providers, refer to support web site:
http://support.sony-europe.com/TV/DVBC
3
Press
G
/
g
/
f
to select “Start”.
The TV starts searching for channels. Do not press
any buttons on the TV or remote.
~
Some cable providers do not support “Quick Scan”. If no
channels are detected using “Quick Scan”, perform “Full
Scan”.
Detaching the Table-
Top Stand from the TV
~
Do not remove the Table-Top Stand for any reason other than
to wall-mount the TV.
Auto Start Up
Language
Country
Select:
Confirm:
Back:
Back:
Start:
Cancel:
MENU
Do you want to start automatic tuning?
KDL-40S30xx
KDL-40D28xx
KDL-40D27xx
KDL-40D26xx
KDL-40T28xx
KDL-40T30xx
KDL-32S30xx
KDL-32D28xx
KDL-32D27xx
KDL-32D26xx
KDL-32T28xx
KDL-32T30xx
010COV.book Page 6 Thursday, July 12, 2007 3:45 PM
