23
Installing into Video Monitors
Installing into Video Monitors
Each adaptor can be installed in any input option slot of the
monitor.
Be sure to turn your video monitor’s MAIN POWER
switch off and unplug the AC power cord from your
monitor before installing or removing adaptors.
1
Remove the cover of an input option slot on the rear
panel of your video monitor.
2
Insert the adaptor below the alignment mark on the left
of the upper screw hole of the slot.
3
Push the adaptor in until it is firmly seated in the
connector inside your video monitor.
4
Tighten the both screws to retain the adaptor.
• The covers of input option slots have radiation shields on
their left side. Handle the covers with care to avoid
damaging them.
• When you remove the installed adaptors and reattach the
covers to the input option slots, be sure to attach them
with the radiation shields facing left.
• If you attach the covers upside down, or attach the covers
with damaged radiation shields, your monitor may not
conform to the radiation standards.
Check that the video monitor’s
MAIN POWER switch is off, and
then unplug the AC power cord.
Cover of an
input option
slot
Insert the
adaptor below
the mark.
Alignment
mark
Notes
Radiation
shield
Cover of an input
option slot (left side)
Top
Bottom
Summary of Contents for BKM-61D
Page 26: ...26 ...
