18
Assembly
Joining the Monitor
Even when the control unit is not joined to the monitor, the
attachment stand can be attached to the monitor alone.
For assembly, see steps
3
to
9
“Joining the Monitor and the Control Unit”.
Lowering the Height
The installation height of the attachment stand can be
lowered when you remove the tilt units pre-installed on the
right stand and the left stand. Remove the tilt units before
the control unit is joined to the monitor.
After the tilt units are removed, the monitor cannot tilt.
1
Loosen the tilting screws on the right stand and left
stand.
2
Remove seven screws from each of the right stand and
left stand.
3
Remove the tilt units from the right stand and left
stand.
4
Secure the supplied screw C (5 × 10) on each stand,
and then secure the tilting screws.
Raising the Height of the attachment stand
Follow steps
1
to
4
in “Lowering the Height” in reverse
order.
Store the removed screws carefully for future use.
Note
Tilt unit
Tilting screw
Note
Screw C
Tilting screw