16
Assembly
5
Place the monitor on the control unit with the stands
attached. Attach the monitor to the stands using four
screws B (4 × 8), adjusting the positions of the screw
holes of the rear stays and control unit.
Place the protrusion of the control unit into the hole of
the rear stay as shown.
6
Place the joint on the right stand, and fix the right stand
on the rear (right side) of the monitor using three
screws B (4 × 8).
7
Place the joint on the left stand, and fix the left stand on
the rear (left side) of the monitor using three screws B
(4 × 8).
8
Attach the right upper cover and left upper cover to the
stands using two screws A (3 × 8) each.
9
Attach the right lower cover and left lower cover to the
stands using four screws A (3 × 8) each.
When the tilt unit is attached
Put the cover over the stand from above.
Screw B
Control unit
Stand (right)
Protrusion
Joint
Stand (right)
Screw B
Joint
Stand (left)
Screw B
Upper cover
Screw A
Lower cover
Screw A
