23
AM-NX9
Power Supply Adjustment Auto Item Feed
Note:
This mode is available to perform the temperature correction and
power supply adjustment without entering the manual mode.
• Setting method of power supply adjustment auto item feed mode.
1. Set the test mode (see page 13)
2. Press the
.
key to activate the overall adjustment mode.
3. Press the
[DOWN LOARD]
key to set the temperature correc-
tion mode.
4. To change the initial value adjust with the
[VOL +]
or
[VOL --]
key.
Press the
u
/ENTER
key to write the adjusted value, and the
item number increases automatically.
When not writing the adjusted value, press the
>
key to move
to the next item.
5. Connect a digital voltmeter to the measuring points on the
MAIN board, and adjust the voltage with the
[VOL +]
or
[VOL --]
key. (see page 18 to 21)
Press the
u
/ENTER
key to write the adjusted value, and the
item number increases automatically.
6. When not writing the adjusted value, press the
>
key to
move to the next item. The
.
key is available to back to the
last item.
7. The following message is displayed after all power supply
adjustments finish.
8. Press the
STOP/CANCEL
x
key to return the test mode (dis-
play check mode).
• Configuration of power supply adjustment auto item feed
Set LCD display
A s s y * *
000
Set LCD display
S e t T m p
015
Set LCD display
V C 1 L
741
Set LCD display
A D J O K
000
.
key
>
key
.
key
>
key
.
key
>
key
VOL –
key
000Assy
**
015 Set Tmp
741 VC1 L
742 VC1 H
743 VC2 Lo
.
key
>
key
>
key
>
key
>
key
.
key
>
key
.
key
>
key
749 REG3 H
751 VREC L
752 VREC M
753 VREC H
>
key
000 ADJ OK
.
key
.
key
>
key
744 VC2 Hi
745 REG1
.
key
747 REG3L1
748 REG3L2
.
key
>
key
.
key
Summary of Contents for AM-NX9
Page 30: ...30 AM NX9 MEMO ...
Page 61: ...61 AM NX9 MEMO ...
