Specifications
HARD DISK RECORDERS / FLEXICART
46
DSR-DR1000P
Hard Disk Recorder
General
Power requirements
AC 100 V to 240 V, 50/60 Hz
Power consumption
60 W
Operating temperature
5 °C to 40 °C (41 °F to 104 °F)
Storage temperature
-20 °C to 60 °C (-4 °F to 140 °F)
Operating humidity
Less than 80%
Storage humidity
Less than 90%
Mass
7.5 kg (16 lb 10 oz)
Dimensions (W x H x D)
210 x 130 x 422 mm (8 3/8 x 5 1/8 x 16 5/8 inches, without projection)
Video Performance
Bandwidth
Luminance: 25 Hz to 5.0 MHz +1.0
(via analogue component I/O)
Chrominance: 25 Hz to 2.0 MHz +1.0/-2.0 dB
S/N ratio
More than 54 dB
(via analogue component I/O)
K-factor (K2T, KPB)
Less than 2%
Y/C delay
Less than 30 ns
Audio Performance
Frequency response
2CH mode (48 kHz/16-bit): 20 Hz to 20 kHz ±1.0 dB
4CH mode (32 kHz/12-bit): 20 Hz to 14.5 kHz ±1.0 dB
Dynamic range
More than 87 dB
Distortion (THD + N)
Less than 0.07% (48 kHz)
Input Signals
VIDEO (ANALOGUE)
REF. Video: BNC (2)
0.3 Vp-p, 75
Ω
sync negative
Composite Video: BNC (2), loop-through connection (*
1
)
1.0 Vp-p, 75
Ω
, sync negative
Component: BNC (3) (*
1
)
Y: 1.0 Vp-p, 75
Ω
, sync negative
R-Y, B-Y: 0.7 Vp-p, 75
Ω
(100% colour bar)
S-Video: BNC (2) (*
1
)
Y: 1.0 Vp-p, 75
Ω
, sync negative
C: 0.3 Vp-p, 75
Ω
(at burst level)
VIDEO (DIGITAL)
SDI: BNC (1)
Conforms to Serial Digital Interface (270 Mb/s), ITU-R BT.656
i.LINK (DV): 6-pin (1)
IEEE 1394-based
AUDIO (ANALOGUE)
Audio: XLR 3-pin female (2)
-6/-3/0/+4 dBu (selectable by menu), high impedance
AUDIO (DIGITAL)
AES/EBU: BNC (2)
75
Ω
, unbalanced
Time Code
BNC (1), 0.5 Vp-p to 18.0 Vp-p, 3 k
Ω
unbalanced
Output Signals
VIDEO (ANALOGUE)
Video 1/2 (SUPER): BNC (2) (*
2
)
Composite, 1.0 Vp-p, 75
Ω
, sync negative
Component: BNC (3) (*
2
)
Y: 1.0 Vp-p, 75
Ω
, sync negative
R-Y, B-Y: 0.7 Vp-p, 75
Ω
(100% colour bar)
S-Video: BNC (2) (*
2
)
Y: 1.0 Vp-p, 75
Ω
, sync negative
C: 0.3 Vp-p, 75
Ω
(at burst level)
VIDEO (DIGITAL)
SDI: BNC (2)
Conforms to Serial Digital Interface (270 Mb/s), ITU-R BT.656
i.LINK (DV): 6-pin (1)
IEEE 1394-based
AUDIO (ANALOGUE)
Audio: XLR 3-pin male (2)
-6/-3//0/+4 dBu (selectable by menu)
Monitor: RCA (1)
-9 dBu, 47 k
Ω
, unbalanced (-18 dBFS), volume center
Headphone: JM-60 headphone jack (1)
-
∞
to -11 dBu, 8
Ω
, unbalanced (-18 dBFS)
AUDIO (DIGITAL)
AES/EBU: BNC (2), 75
Ω
, unbalanced
TIME CODE
BNC (1), 2.2 Vp-p, 600
Ω
, unbalanced
REMOTE
RS-422A: D-sub 9-pin, female (2)
Control: Mini jack (1)
Network
Ethernet (1): 10Base-T/100Base-TX Ethernet, RJ-45 modular jack
DSR-DU1
Hard Disk Recorder
General
Power requirements
DC 7.2 V (battery), DC 8.4 V (AC adaptor)
Power consumption
5.6 W
Mass
500 g (1 lb 1 oz)
Dimensions
(W x H x D) 44 x 101 x 142 mm
Operating temperature
0 °C to 40 °C
Storage temperature
-20 °C to 60 °C
Operating Humidity
Less than 85 % (without dew condensation)
Input/Output Terminals
DV IN/OUT
i.LINK x1 (IEEE1394 4-pin)
Remote
4-pin Stereo mini Jack x1
DC IN
x1
Supplied Accessories
Warranty card
Operation manual
i.LINK cable (4-pin to 4-pin)
Remote controller (RM-LG2)
Battery (CR2032)
Case
