14
GB
7: Performing the initial
set-up
1
Connect the TV to your AC power
outlet (mains socket).
2
Press
1
on the TV. The
=
(power)
indicator will light up in green.
When you switch on the TV for the first
time, the Language menu appears on the
screen.
~
•
When you turn on the TV for the first time, the
TV requires some internal processing for
optimization before you can perform the
initial setup. There will be no picture and
sound, and the timer indicator on the front of
the TV blinks orange for about 40 seconds. Do
not turn off the TV during this process.
This process has been completed at the factory
for some TVs.
Follow the instructions on the screen.
Satellite Auto Tuning:
The following procedures may be required
depending on the area:
1
Please select “Preferred Satellite” or
“General Satellite”.
2
For “Preferred Satellite”, select your
preferred operator.
“Satellite Auto Tuning” automatically
tunes in available satellite channels. Digital
Satellite Equipment Control (DiSEqC) 1.0
management allows setting of up to four
different channels. The following settings
are independent for each connection. To
set-up DiSEqC input in the “DiSEqC
Control”, use “LNB Configuration”.
1
“Scan Type” and “Advanced Settings”
(for common satellite setting- Satellite 1
to 4):
Allows you to set tuning settings in more
detail to better find the type of services you
would prefer to tune.
“Scan Type”:
If no channel is found using
“Network Scan”, try “Full Scan”.
“Full Scan”:
Performs a complete
frequency scan and guarantees tuning to
all possible programmes for the currently
set LNB configuration. Previously-tuned
programmes will be lost.
“Network Scan”:
Performs a scan in the
transponders of a network (aka NIT
scan). Since “Network Scan” is faster
than “Full Scan”, it is recommended
when tuning to a known network
(normally associated with a satellite). A
transponder must be specified, from
which network information (other
transponders) will be retrieved.
Previously-tuned programmes will be
lost.
2
“LNB Configuration” (for each satellite
setting- Satellite 1 to 4):
In the case of a non-standard LNB (low-
noise block), manual setting is available.
–
In the case of a single satellite channel,
you can leave it on the initial setting.
–
For two satellite channels, you need to
set “Toneburst A” (1st satellite) and
“Toneburst B” (2nd satellite) in the
“DiSEqC Control” setting.
3
Except KDL-46/40/
32CX52x
KDL-46/40/32CX52x
