SMX SERIES
page 13
TROUBLESHOOTING
Effects cannot be
• Are the [FX] knobs for each channel adjusted to appropriate levels?
applied
• Is the [ON] button for [FX RTN] turned on?
• Are the [PARAMETER] knob and [FX RTN] fader adjusted to
appropriate levels?
• Is the [FX RTN] bus assign switch set appropriately?
• If external effects are connected to the [SEND(AUX1 – 4)] jacks, are
the [AUX1 – 4] knobs for [SEND MASTER] set appropriately?
Voices are not clear
• Is the [HPF] switch turned on?
• Is the equalizer ([HIGH]/[MID]/[LOW]) adjusted appropriately?
No output from
• Are powered speakers connected to the [MONITOR OUT] jacks?
MONITOR OUT
Use the [MONITOR LEVEL] knob to adjust the signal output from the
[MONITOR OUT] jacks.
Left and right levels are
• Is [PAN] set to the center? If panned to the center, try reversing the
different for a stereo
left and right input connections. If, after switching the left and right
signal input
connections, the side with the low volume level also switches, check
the instrument or device that is the source of the signal.
• Are you using the same type of cable to connect both the left and
right input signals? Cables with built-in resistors will attenuate the
signal.
The sound level is
• Is the compressor level set too high? Use the TRIM knob to lower the
unstable and
inconsistent
level
