Owner’s Manual
Front Grill Brush - SF50
© 2021
SONNY’S The CarWash Factory
®
. All Rights Reserved.
SonnysDirect.com
This document is confidential and proprietary to SONNY’S and cannot be used, disclosed or
Page 9 of 26
published without prior written consent. Content, prices, and availability subject to change without notice.
Manual-O, Front Grill Brush 16v1
– Rev 2021-A
*INSTALLATION*
Utilities Requirements
UTILITIES INTERCONNECTION AND THE MATERIALS REQUIRED FOR
INTERCONNECTION TO SONNY’S EQUIPMENT ARE THE RESPONSIBILITY OF THE
CUSTOMER !
PERFORM ALL TRADES WORK TO ALL APPLICABLE LOCAL AND
NATIONAL CODES !
Water
•
The Customer's Plumber is to provide and install a 1/2 inch city water line @ 60PSI
(nominal) to the solenoid valve on the chemical distribution system for the Washer.
Electrical
•
The Customer's Electrician is to provide and install single phase power from the (24 or
110
VAC as determined at time of order) from the Customer’s Controller system to the
liquid solenoid valve for the brush spray bars and, if required, the motor starter coil for the
hydraulic power pack feeding the two brushes and any pump motor for the chemical
distribution system.
•
Where applicable, t
he Customer’s Electrician is to provide materials and install 208VAC
or 230VAC or 460VAC, 3-phase, 60Hz power to the electric motor on the hydraulic power
pack or VFD panel from a properly sized three pole circuit breaker and motor starter with
three thermal overloads.
Optional Retract Kit Requirements
Electrical
•
The Customer's Electrician is to provide and install single phase power from the remote
push-button station through the tunnel equipment programmer to the supplied air
solenoid valve on the Air Distribution Manifold for retract of both washers upon selective
signal (See Figure #6 in Dimensions Section).
Compressed Air
•
The Customer's Plumber is to provide and install a 1/2 inch compressed air line from the
Air Compressor to the Air Distribution Manifold for the Retract functions.