Owner
’s Manual
Pendulum 807W Combo
© 2021 SONNY’S The CarWash Factory
®
. All Rights Reserved
SonnysDirect.com
This document is confidential and proprietary to SONNY’S and cannot be used, disclosed or
Page 14 of 21
published without prior written consent. Content, prices, and availability subject to change without notice.
QUICK FIX - Pendulum 807W Combo.docx
– Rev 2021-A
24.
With a helper on the driver’s side ladder, have him put two three (3”) inch bolts with
washers through the lowest holes in the pivot arm (the two holes closest to the ground).
Helper # 2 will now hand helper # 1 an angle cut 25” brace, which helper # 1 will slide on
the 3” bolts he just put into the pivot arms. Secure hand tight with a flat washer, lock
washer and nut. Do the same on the passenger’s side.
25.
Have a helper on a ladder on the driver’s side and put two (2) 5.5” bolts and flat washers
through the TOP of the lower cross member and the angle brace. Secure brace to cross
member with flat washers, lock washers and hand tighten nut. Do the same on the
passenger’s side.
26.
On driver’s side, have a helper on a ladder with four (4) 3.5” bolts with flat washers
installed. Slide the 3.5” bolts through the upper mount holes for the lower cross member
(the ones left empty is step 24) and also the two holes directly above those for the 25”
angled brace.
27.
Slide the 25” angled brace over the 3.5” bolts, then slide the 4” X 14” plate onto those
bolts AND the upper two 3.5” bolts for the lower cross member. Place a flat washer, lock
washer and nut on each of the four bolts and hand tighten. Slide two 5.5” bolts and flat
washers through the two holes in the upper cross member and upper 25” angled brace.
Secure with a flat washer, lock washer and nut. Hand tighten the bolts.
28.
Move to passenger’s side and follow the same procedure.
29.
Staying on the passenger’s side, locate the Pendulum lower arm with two “pillow block”
bearings attached, four
1.5” bolts, four flat washers, and four lock washers.
30.
Loosen the set screws on the “pillow block” bearings in case adjustments are needed to
mount bearings to the swing arm plate. Secure the bearings to plate mount on
passenger’s side Pendulum swing arm. You may tighten the bolts securely.
31.
Center the lower arm between the “pillow block” bearings and tighten the set screws
firmly securing the shaft to the bearings.
32. Locate
the Pendulum “Roller Arm” assembly. Along with four 2” bolts, eight flat washers,
four lock washers and four nuts.
33.
Slide a flat washer onto each of the four 2” bolts, and slide the bolts through the lower
arm, with the threads pointing towards the ground. Secure each bolt with flat washer, lock
washer and a nut. Keep hand tight for now.
34.
Locate one of the two spinner / can assemblies, and four 3” bolts and 8 flat washers. You
will need two bolts per side. Move the whole are back and forth to check for smoothness
of movement. If no binding is present, then move to the next step.
NOTE: The spinner assembly has two mounting positions. If most of your business is
vehicles with 15”-18” rims, then use the lower mounting position. If you have trucks and
