Owner
’s Manual
Pendulum 807W Combo
© 2021 SONNY’S The CarWash Factory
®
. All Rights Reserved
SonnysDirect.com
This document is confidential and proprietary to SONNY’S and cannot be used, disclosed or
Page 13 of 21
published without prior written consent. Content, prices, and availability subject to change without notice.
QUICK FIX - Pendulum 807W Combo.docx
– Rev 2021-A
14. Follow the same steps from above to install the exit end cross member.
15.
Locate the four (4) 25” long, angle cut braces. Have 16 ½” X 5.5” SS bolts ready with
washers already on the bolts. Starting at the passenger side, entrance end, have helper
#1 on a ladder. Helper # 1 slides the two bolts through the leg assembly, then slide the
25” angle cut brace over those bolts. Insert upper bolts through the upper cross member,
and hand tightened with NYLON LOCK BOLTS. Follow the same steps for the remaining
three braces, leaving ALL bolts finger tight till the end.
16. Raise the Mitter frame using a forklift and bolt into place.
17.
Locate the black UHMW (plastic) block. The plastic block will already have four (4) ½” X
9” bolts through it and the aluminum flat bearing mount cap. Unscrew the four nuts and
washers from each black plastic bearing block. Have helper #1 climb the ladder on the
driver’s side and slide the four bolts through the pre-drilled holes ON TOP of the now
assembled leg assembly. Replace washers removed and secure the nylon bolts
to the ½”
X 9” SS bolts, finger tight.
18. Locate the Pendulum pivot arms. The passenger side has a plate on the bottom, and the
driver’s side has a pivot shaft on the bottom. Both arms will have a stainless shaft pre-
installed, with two split clamps on the shaft. Loosen the inside split clamp so it can slide
and remove the oute
r split clamp and set aside. Starting on the driver’s side, slide the
pivot arm through the black plastic bearing. Slide the split clamp onto the end of the
stainless shaft and leave loose for now.
19.
Follow step #17 for passenger’s side.
20. Locate the sixteen
(16) 3”, eight (8) 3.5”, and eight (8) 5.5” long SS bolts. Place flat
washers on each bolt and have ready. This will expedite the assembly process.
21.
Locate the two pivot arm cross members, four 25” long angle braces and two 4 X 14” flat
cylinder mount plates (there is a stud in the middle of the plate).
22.
Have helper # 1 on the passenger’s side, with a ladder set under the center of the frame
assembly. Helper #1will pick up one of the two pivot arm cross members, holding steady
for helper # 2 who is alread
y on a ladder on the driver’s side in the center of the frame
assembly.
****Be cautious of the conveyor and grating on the driver’s side.
Helper
#2, on driver’s side, will locate the SECOND (LOWER) SET of four (4) holes on the
driver’s side pivot arm, and slide TWO thee (3) inch bolts through the BOTTOM holes
only(do not put bolts through the upper holes yet). Have helper #1 do the same on the
passenger’s side.
23. Follow the same procedure as step #21, for the upper pivot cross member. This time
secure the cr
oss member with four (4) three (3”) inch bolts. Make sure to place a flat
washer on the bolt beforehand tightening the nut. Follow the same procedure for the
passenger side.
