Sedley USB installation (PC with XP installed):
As the Sedley USB section is powered by the USB port, the Sedley does not
need to be connected to the mains for installation or PC music playback.
Installation:
If your PC is not already switched on, switch on your computer.
Connect the Sedley to the PC using the USB cable provided.
Your computer should have detected your Sedley as “
USB Audio CODEC
”
and begin auto installation (You may be asked for your Windows Disks).
You will then see several messages regarding different USB devices being
installed, this is completely normal.
When done you will see a message saying your device is ready (USB Audio
Codec).
The Sedley installation is now finished. Please proceed with software
installation in the next section (required if you want to record using your PC).
Note:
You can disconnect the USB cable when you are not using the Sedley for
backing up vinyls or playing music files from your PC to your Hi Fi system.
The Sedley USB is hot-pluggable - no need to switch the system off when
connecting and disconnecting the USB cable.
When plugged to a different USB port on your PC the installation sequence
shown above may occur again, this is completely normal.
