Sonnenkonig 10501401, User Manual

Page: 57 / 65

56 57
EN
Caution: Do not turn the fan forcibly by hand.
When the fan automatically rotates at a certain
angle, do not turn it back forcibly by hand or it
might damage the internal structure.
To rotate the angle, please press the swing up and down button.
Turning On and Off (in Standby Mode)
• If the device is in standby mode, the motor will begin to run when the power button is pressed.
• The device changes from running mode into standby mode when the power button is pressed.
Speed Control (SPEED)
• Air speed can be controlled by turning the rotary knob on the body of the air circulator
fan or by pressing the “+” and “-” buttons on the remote control.
• When the device is in running mode and the rotary knob is turned clockwise, the power
of the motor will gradually increase (from level 1, 2, 3 …) until it reaches its maximum
(level 8). If the rotary knob is turned anticlockwise, the power of the motor will gradually
decrease (from level 8, 7, 6 …) until it is in standby mode (OFF).
• When the device is in running mode and the “+” button on the remote control is pressed,
the power of the motor will change from a low level to a high level until it reaches its
maximum (level 8) without any further changes. If the “-” button on the remote control
is pressed, the power of the motor changes from a higher level to a lower level until it
reaches its minimum (level 1) without any further changes.
• Corresponding to the selected speed level, the indicator lights of respective level and all
the levels below will light up.
For example: At level 1, the indicator light of level 1 is on; at level 8, the indicator lights of
levels 1 – 8 are all lit up.
Swing Control (SWING)
• In running mode, both swinging up and down as well as swinging left and right can be
selected if the corresponding buttons on the body of the air circulator fan or the remote
control are touched or pressed. Swinging left and right and swinging up and down are
available at the same time.
• The swing function is initially turned off. When touching or pressing buttons on the body
or the remote control, the user will hear one beep (which means swing function is on) or
two beeps (which means swing function is off).
• In running mode, the indicator lights of the buttons are on while in standby mode the
lights are off.
• The buttons are designed with a memory effect, i. e. when the motor was in standby
mode and is turned back on, the swing function will be the same it had been before the
motor was turned off.
2. PRODUCT INSTRUCTIONS