Sonnenkonig 10300001, User Manual

Page: 73 / 80

73
6 How to operate the fan
1.
Connect the plug to a power outlet and check that the indicator light is lit as shown in the
figure below.
2.
Press the “ON/SPEED” button to select the air current speed from Low, Med, High ac-
cording to the light signal that appears on the control panel.
3.
Press the “WIND” button to select the air type. The corresponding light will illuminate.
“Normal”: The airflow is produced according to the set low/medium/high speed.
“Natural”: A natural air current is imitated in strong and weak winds.
“Sleeping”:
For the first half hour the fan will operate in the “natural current”
mode with strong and weak wind, then it will become medium. In the second
half hour the fan will switch to weak natural wind until the end of the set time.
4.
Press the “SWING” button to change the direction of the airflow. The corresponding light
will illuminate. Pressing this button again will disable the oscillation.
5.
Press the “MIST” button. The corresponding indicator light will illuminate and water
spray will be emitted from the front nebulizer. The “MIST” button can be used separately
or combined with the fan to produce the effect of fresh wind. Separate use of this feature
may increase air humidity
6.
Press the
“TIMER”
button to set the fan running time between 1 and 9 hours. At the end
of the set time, the fan will switch off. To set a time of 1 hour the button must be pressed
once, to set a time of 9 hours the button must be pressed 9 times.
7.
Press the
“ION”
button. The corresponding indicator light will illuminate and the ionizer
will produce anions that will propagate into the room air in such a way that dust, pollen,
mould spores, pet particles, etc., that are suspended in the air agglomerate and precipi-
tate. The “ION” button can be used separately or combined with the fan.
Note : After a certain ionizer run time some dirt will form around the anion generator
opening. This is a normal phenomenon due to the effect of anions and you can easily
clean the area around the opening.
8.
Press the
“MOSQUITO REPELLENT”
button. The respective light lights up and by means
of the vapour supply to the anti mosquito cushion a specific odor repelling substance will
propagate. It is necessary to insert a common mosquito plate (not supplied) into the slot
on the back of the appliance. The “MOSQUITO REPELLENT” button can be used separately
or combined with the fan.
EN