Sonnen sonnenBatterie hybrid 9.53, Operating Instructions Manual, Page: 20 / 28

5 | Digital sonnen world
20 / 28 Operating instructions sonnenBatterie hybrid 9.53
5.2.5 Settings page
Depending on the configuration of your storage system, the following areas are displayed
on the Settings page:
Operating Mode
Operating Mode Self-Consumption is normally used.
The other two operating modes (Time of Use (time linking) and Battery-Module-Extension
(30%) (module extension)) are only required in certain cases and should only be set by the
electrician performing the installation.
Backup-buffer
If a sonnenProtect is connected to the storage system, the Backup-buffer field is dis-
played. You can select the backup buffer as a percentage here. This portion of the storage
capacity is then reserved for the backup supply, i.e. this portion of the capacity is not avail-
able to the storage system in normal operation.
Combined heat and power unit (CHP)
If a CHP with constant power output is connected to the storage system and has been set
up appropriately by the installer, the Combined Heat and Power (CHP) field is displayed.
The Power specifies the constant power of the CHP and should not be changed after initial
configuration by the installer. The lower limit of the charging state at which the CHP is ac-
tivated (Charge state to start CHP) and the upper limit at which the CHP is stopped
(Charge state to stop CHP) are specified as percentages.
„
Contact your installer before changes are made to the settings.