© 2018 Sonim Technologies Inc. All Rights Reserved.
1825 S. Grant Street Suite 200, San Mateo, CA 94402- USA
Tel : +1.650.378.8100 Fax : +1.650.378.8109
cet équipement pour maintenir une distance de séparation minimale de 1.0 cm entr e le corps de l'utilisateur et
l'appareil. Ces accessoires ne doivent pas contenir des composants métalliques . Il est possible que les accessoires
utilisés près du corps qui ne répondent pas à ces exigences ne sont pas compatibles avec les limites SAR et il est
conseillé d'éviter de les utiliser.
XPand Direct Mode for XP5s
Model ACX03G
FCC ID WYPACX03G
IC ID
8090A-ACX03G
SAR
The highest SAR value for the model ACX03G as reported to the FCC when tested for use in front of
face is 0.58W/kg, and when worn on the body, as described in this user guide, is 0.44W/kg (body
worn
measurements differ among device models, depending upon available accessories and FCC
requirements).
XPand Direct Mode for XP8
Model ACX04G
FCC ID WYPACX04G
IC ID
8090A-ACX04G
SAR
The highest SAR value for the model
ACX04G
as reported to the FCC when tested for use in front of
face is 0.85W/kg, and when worn on the body, as described in this user guide, is 1.02W/kg (body
worn measurements differ among device models, depending upon available accessories and FCC
requirements).
Professional installation instruction
1.
Installation personal
This product is designed for specific application and needs to be installed by a qualified personal who has RF and
related rule knowledge. The general user shall not attempt to install or change the setting.
2.
Installation location
The product shall be installed at a location where the radiating antenna can be kept 1
.0
cm from nearby person in
normal operation condition to meet regulatory RF exposure requirement.
3.
External antenna
Use only the antennas which have been approved by the applicant. The non-approved antenna(s) may produce
unwanted spurious or excessive RF transmitting power which may lead to the violation of FCC Part15C Canada
limit and is prohibited.
4.
Installation procedure
Please refer to manual for the detail.
5.
Warning
Please carefully select the installation position and make sure that the final output power does not exceed the
limit set force in relevant rules. The violation of the rule could lead to serious federal penalty.
Instructions d'installation professionnelle
1.
Installation
Ce produit est destine a un usage specifique et doit etre installe par unpersonnel qualifie maitrisant les
radiofrequences et les regles s'y rapportant. L'installation et les reglages ne doivent pas etre modifies par
l'utilisateur
final.
2.
Emplacement d'installation
En usage normal, afin de respecter les exigences reglementaires concernant l'exposition aux radiofrequences, ce
produit doit etre installe de facon a respecter une distance de 1
.0
cm entre l'antenne emettrice et les personnes.
3.
Antenn externe.
