SonicWALL TZ 190 Getting Started Guide Page 23
Setting Up Your SonicWALL TZ 190 Appliance
This section contains the following sub-sections:
•
“Insert the WWAN PC Card Modem” on page 23
•
“Apply Power to the SonicWALL TZ 190” on page 23
•
“Connect Directly to the SonicWALL TZ 190 Appliance” on page 24
•
“Log into the SonicWALL TZ 190 Appliance” on page 25
•
“If the SonicWALL Configuration Wizard Does Not Appear” on page 25
Insert the WWAN PC Card Modem
Before inserting the WWAN PC card into your SonicWALL TZ 190 appliance, be sure
your WWAN PC card is activated and unlocked. If you are not sure whether your card is
unlocked or not, contact the PC Card vendor to verify.
Note:
Do not insert or remove the WWAN PC card while the SonicWALL TZ 190 is
powered on.
1.
Ensure the TZ 190 is
not
connected to a power source.
2.
Insert your WWAN PC card modem “face up” into the PC CARD slot on the left side
of the SonicWALL TZ 190 appliance. The card should sit firmly in place.
Apply Power to the SonicWALL TZ 190
1.
Connect one end of the power supply to the back of the SonicWALL TZ 190
appliance.
2.
Connect the other end of the power supply an appropriate power outlet.
Note:
The Power
LED on the front panel lights up green when you power the
SonicWALL TZ 190 appliance. The Test
LED lights up and blinks while the
appliance performs a series of diagnostic tests. When the Test LED is no longer
lit, the SonicWALL TZ 190 appliance is ready for configuration. If the Test
LED stays lit for more than a few minutes after the initial power on sequence,
cycle power to the SonicWALL TZ 190 appliance.
3
2
4
link/act
10/100
signal
link/act
wan opt
WWAN
TZ 190
