Page 18
Configuring Appliance Settings
Configuring a Static IP Address for the Appliance
This procedure describes how to configure your SonicWALL
CDP appliance with a static IP address. After changing the IP
address of your appliance, you must point your browser to the
new IP address to access the Web management interface.
For your records, enter the chosen IP address for your
SonicWALL CDP appliance in the space provided below.
1.
In the Web management interface, click
Network
in the
navigation pane, and then click
Settings
.
2.
On the
Interfaces
tab, click the Configure icon for the
eth0
interface.
3.
In the
ip
field, enter an unused static IP address that is
within the range of your local subnet.
For example, if the LAN IP address of your gateway firewall
is 10.215.10.1 and the subnet mask is 255.255.255.0, you
could set the static IP address on your SonicWALL CDP
appliance to 10.215.10.61.
4.
In the
netmask
field, enter your subnet mask.
5.
In the
gateway
field, enter the IP address of the default
gateway (usually a firewall) for your local network.
6.
Click
Save
. A Processing indicator is displayed, but your
session is already disconnected and you do not need to
wait.
Note:
After applying the IP address change, your current
Web management interface session is disconnected.
You must point your browser to the new IP address to
access the Web management interface again.
7.
Disconnect the crossover cable from your computer and
from the SonicWALL CDP appliance.
SonicWALL CDP IP
address
:
See
Networking
Information - page 7
______.______.______.______
Summary of Contents for CDP 5040
