13
P/N 1010926 Rev. B 04/12
Sonic
Vertical contact toaster
A.J. Antunes & Co.
trOUblesHOOtinG (continued)
Problem
Possible cause
corrective action
Product is over toasted,
Platen heat is too high,
or drop time is too slow.
temperature set too high.
Set temperature control to a lower setting.
Bun thickness compression
Knobs set improperly.
Measure bun thickness and set Bun thickness
compression Knobs correctly.
Buns sticking on Release Sheet. clean or replace Release Sheet according to the
procedure in the Maintenance section of this manual.
conveyor cover assembly not
installed properly.
Re-install conveyor cover assembly.
Loose Sprocket Setscrews.
check drive chain for kinks, broken or bent links,
or other damage. check motor sprocket and drive
sprockets; tighten setscrew on flat of shaft if required.
check for damaged/worn sprocket and replace as
required.
conveyor Belt chain too loose.
adjust conveyor Belt chain length as described in the
Maintenance section of this manual.
Spring tensioner assembly is
damaged or missing.
Replace Spring tensioner assembly if damaged or
missing.
Product is under toast-
ed, Platen heat is too
low, or drop time is too
fast.
Bun thickness compression
Knobs set improperly.
Measure bun thickness and set Bun thickness
compression Knobs correctly.
Wiring problem.
contact your maintenance person or authorized
Service agency for service.
inoperable thermostat.
Conveyor Drive Motor inoper-
able or incorrect conveyor motor
or sprocket installed.
Product is getting
stuck, or conveyor Belt
chains stop when
product is toasting.
Bun thickness compression
Knobs Set improperly.
Measure bun thickness and set Bun thickness
compression Knobs correctly.
Release Sheet not cleaned
properly, is missing, or is too
old.
clean or replace Release Sheet as described in the
Maintenance section of this manual.
Conveyor Drive motor inopera-
tive or incorrect voltage motor
installed in toaster.
contact your maintenance person or authorized
Service agency for service.
Conveyor Drive Chain loose,
worn, or broken. Loose motor
drive sprocket.
check drive chain for kinks, broken or bent links,
or other damage. check motor sprocket and drive
sprockets, tighten setscrew on flat of shaft if required.
check for damaged/worn sprockets and replace as
required.
conveyor Belt chain too loose.
adjust conveyor Belt chain length as described in the
Maintenance section of this manual.
Spring tensioner assembly is
damaged or missing.
Replace Spring tensioner assembly if damaged or
missing.
Release Sheet is sticky and not
smooth (due to improper clean-
ing or excessive butter/oil
accumulation.
Clean Release Sheets according to the Daily Cleaning
section of this manual. Replace if the Release Sheet
is still sticky after cleaning.
