9
Wow and Flutter
Below measurable levels
Jitter
<2 ps rms, to 40 kHz at the clock
Typically 10ps rms, at the outputs
(independently verified with UltraAnalog’s
latest Jitter Analyzer
Digital Outputs (5)
AES/EBU
Balanced on XLR-3 connector
Impedance
110 ohms, ±5%
Level
3.0 p-p typ with 110ohm load
Tr=Tf
7ns, typ
S/PDIF
Single ended RCA connector
Impedance
75 ohms, ±5%
Level
0.5V p-p typ with 75 ohm load
Tr=Tf
8 ns, typ
SPDIF
Single ended BNC connector
Impedance
75 ohms, ±5%
Level
0.5V p-p typ with 75 ohm load
Tr=Tf
8 ns, typ
Glass-ST
HP HFBR-1414
Power
60uw into 62 um fibre
I
2
S
•
e
13W3 style “D-sub” miniature connector
Level 2 implementation of
I
2
S
•
e
Impedance
3-Coax 75ohms, ±5%
(Transmission lines)
5-Twisted Pair 110ohms, ±5%
Tr=Tf
Ins typ (ecl.)
Laser Semiconductor
GaAIAs, 0.5mw, continuous, 790nm
Sampling Rate
352.8 kHz
Disc Rotation Velocity
200-500rpm (constant linear velocity)
Quantization
16 bits, linear
Error correction
CIRC principle
I.R. Jack
TTL level optically isolated
Number of channels
2 channels, stereo
Power Consumption
100-120 VAC 50/60Hz 40VA Max.
200-240 VAC 50/60Hz 40VA Max.
Dimensions: Main -
19.125” Wide x 16” Deep x 4.” High
(49 cm x 40 cm x 10 cm)
Net Weight
Approx. 31.5 lbs (14.3 kg) - unpacked
Warranty
5 years parts and labor
1 year on the mechanism
T EC H NIC AL S PE C IF I CAT I ON S
Note: All measurements performed with an Audio Precision System Two test center.
Due to Sonic Frontiers desire to continually improve its products, specifications are subject
to change without notice.
REM O TE CO N TRO L B ATT ERY REP LAC EMEN T
To replace the remote control batteries, unscrew the top of the
remote from the base and insert batteries as shown below.
I
2
S •
e
nhanced
C O N N E C T O R
The signals are transmitted using a single 13W3 cable between
the transmitter and receiver. The 13W3 connector consists of
three 75
Ω
coaxial transmission lines (referred to as A1, A2 and
A3) and 5 twisted-pair 110
Ω
cables (referred to as pins 1
through 10).
The Master Clock is transmitted from the transmitter to the receiver
in a balanced configuration using two 75
Ω
coaxial transmission
lines. The + phase of the Master Clock is transmitted on A2 while
the - phase of the Master Clock is transmitted on A3.
The Bit Clock, Word Clock, Data, and Channel status signals are
transmitted from the transmitter to the receiver in a balanced con-
figuration using 4 of the 110
Ω
twisted-pair transmission lines.
The Clock Flag is transmitted as single-ended signal with CMOS
compatible levels using the remaining twisted-pair line. The driver
for this signal sources 10 mA so as to be compatible with
receivers that use an input opto-coupler device.
The 13W3 cable’s outer foil shield is connected to chassis ground
at both ends.
