3) The
word
LINK
will begin flashing for up to 1 minute until this part of the setup is
finished.
4) At anytime if you need to exit out simply press the back button to exit.
5) Next Press the
link button
on the back of the HA360DB signaler. On the Master unit
display the word FT DOOR will begin flashing. At this point you have these three options
to select from (FT DOOR, RE DOOR, DOOR 3, DOOR 4). To select one of these four
options you need to scroll through the display using the
TONE
&
MINUTE
buttons. Scroll
up with the TONE button and down with the MINUTE button. When the display shows
the option you want press the
ENTER
button. The red LED light on the front of the
doorbell unit will blink several times during the link process. When done blinking the link
setup is complete, the units are now linked together and ready to use.
Step #5) Placement of the HA360DB doorbell transmitter
Proper placement of the HomeAware doorbell signaler is important because it uses Digital
RF frequencies to send its signal. It’s important to not place or install it on anything made of
metal because RF signals cannot go through metal. The HomeAware doorbell comes with
mounting hardware and is simple to install see Steps 2 & 3 above.
