Step #3) Installation to existing door chime inside
With this method you can install the HA360DB to your existing AC powered doorbell chime.
This method allows you to use the existing doorbell button so there aren’t two buttons
outside.
Use the provided wire to connect the Doorbell Signaler to your existing AC powered chime
box. Remove chime box cover and connect the red and white wires to the existing terminal
screws (common and front) if connecting to the front door. Otherwise connect the red and
white wires to the (common and rear) screws for the rear door.
Next, plug the jack at the opposite end of the wire into the input on the side of the Doorbell
Signaler. To test press the doorbell button on the front, if the red LED lights up the
installation was successful. If the red light does not light up check the wiring again, also
check that the batteries are in correctly, check if chime box has power, also was it working
before you installed the wire?
Use the provided Velcro to attach the signaler next to or under the chime box cover if
enough room. See diagram for Door Chime installation below.
Step #4) Link button setup
This procedure will link your HA360DB to your HomeAware Master unit. The Master unit will
also provide an alert to all HomeAware remote receivers. When using the Sonic Alert bridge
unit HA360BU all original Sonic Alert receivers (SA101, SA201, BL300, and SB1000) will
also alert you.
Its best to do the LINK procedure in the same room with the HomeAware Master unit, make
sure this unit is plugged in.
To link the HA360DB to your Sonic Alert HomeAware Master unit follow the steps below.
1) On the Master unit press the
Set Up
button. Now you will see the work CLOCK on the
display.
2) Next, on the Master unit you’ll need to scroll through the options until you see the word
LINK
. Scroll up or down using the
TONE
&
MINUTE
buttons. Scroll up with the TONE
button and down with the MINUTE button until you see the word
LINK
then press
ENTER
.
