23
d:24 owner‘s manual
Power switch
When pressing the power switch, the controller boots up
and the amplification circuits are activated. Independent
to the status of the control surface (the display), the amp
modules are active until the amp is switched off again.
5
6
8
9
Status LEDs “good” and “on”
Power “good” turns green when the amp is connected to a
power supply (even if the amp is turned off).
Power “on” turns green when the amp is switched on and
the amplification circuits are active.
Digital input option slot
Optionally, the d:24 can be equipped with a MADI (“mio“)
DANTE® (“dio”) input card. The installation of the input card
has to be performed by an authorized service provider or
by sonible. Please contact your local distributor or sonible
(
) fur further information.
Power connector (Neutrik® powerCON)
The maximum current consumption of the amp is 20A.
Therefore, only the original cable shipped with the amp
(2,5mm
2
, H07RN or equal quality) should be used.
(115V/60Hz mains voltage is currently not supported)
Panic Mute Status LED
The panic mute LED flashes red when the panic mute is ac-
tive and all amplifier outputs are muted. It does not distin
-
guish if the mute has been triggered by the hardware panic
button or by the software.
7
Summary of Contents for d24
