©2017 Sonance. All rights reserved. Sonance and Visual Performance are registered trademarks of Dana Innovations. Due to continuous product improvement,
all features and specifications are subject to change without notice. For the latest Sonance product specification information visit our website: www.sonance.com
SONANCE • 991 Calle Amanecer • San Clemente, CA 92673 USA • PHONE: (949) 492-7777 • FAX: (949) 361-5151 • Technical Support: (949) 492-7777
10.24.17
The BPS6 TL ships with a tether inserted into the end
of the port tube. Use the tether to guide the port tube
into the flex bracket. Loop and pull the tether all the
way until port tube lies firmly on the flex bracket.
Tie the tether into a knot. This process ensures that
other tradespersons won’t infringe on the port tube
assembly area. (See Figure 5).
BPS6 TL QUICKSTART GUIDE
FOR USE WITH VISUAL PERFORMANCE SERIES BANDPASS CONNECTORS
Attach the
four conductor speaker wire
to the input
terminals; positive wires to red terminals and negative
wires to black terminals. Run a signal test using an
amplified program material for at least 60 seconds.
Secure the speaker wire to the zip tie attached to the
subwoofer cabinet to prevent accidental removal.
(See Figure 6).
After drywall and paint is complete, install bandpass
connector (sold separately; Sonance model
VPBPC3R TL SKU# 93334) to the port tube through
the flex bracket.
For Visual Performance bandpass connector
installation details visit www.sonance.com/
in-wall-in-ceiling/bps6-tl
33-7940
LEFT
BPS6TL
RIGHT
MADE IN CHINA
6
Included
zip tie
for wire
5
NOTE: PORT TUBE CONTAINS FOAM PLUG WITH A TETHER, MAKE
SURE PRESSURE LEVELS DON’T EXPEL THE FOAM PLUG AND TETHER.
Tether into flex
bracket loop
Foam
Figure 5
Figure 6
