3
what other codes may be used to operate the device. You can move
through all entered codes one by one.
1. Turn on the TV set or other device manually. If you are using a
VCR then also insert a cassette.
2.
Press and hold the SET button then press the button
corresponding to the type of device you want to control: TV, VCR,
SAT, DVD, CD/VCD, LD/HIFI/AUX
3. When the LED display under the LIGHT button starts to light, you
should not push the button any longer.
4. Press the SET button again and then release it. The LED will start
fl ashing, which shows that the remote control unit is in quick
search mode.
5. Direct the remote control toward the device you want to operate
and press the POWER button (if you are using a VCR, press PLAY).
Watch the reaction, whether the TV is turned off or the VCR
starts playing the cassette.** If you succeed, you can stop the
quick search with any button of the remote control (TV, VCR, AUX,
SAT). If the device reacts, test the other buttons as well. If nothing
happens, press the POWER again and again until the device
switches off. The remote control sends a signal corresponding
to the next brand code each time you press the button.
*note:
Due to the versatility of the product and the constantly
increasing number of telecommunication devices in the world
market, it is impossible to prepare an up-to-date list of all
manufacturers, brands and product types compatible with the
remote control.
As manufacturers often take over technologies from one another,
and, in addition, the same manufacturer may use different codes in
its various product lines, there may be several overlaps in operating
codes. In some cases, several codes may operate the device (even
codes assigned to other manufacturers), the only difference being
that one code provides access to more functions than the others,
or sometimes the functions of the buttons may get mixed up.
Therefore, it is advisable to try all codes that operate the device and
then choose the one that provides highest functionality.
**note:
some devices react to signals slower, so make sure you
wait for enough time between pressing the POWER button again
and again. All buttons function properly in code search mode, so
they you can test them before moving on to the next code. Pressing
the SET button changes the search direction.
You can exit the quick search mode by pressing any device selection
button (e.g. TV) or by not pressing any button for 30 seconds.
Reading a selected code
If you fi nd the proper code with the quick search function, it is
advisable to note it down to make its reselection easier. The number
of the fl ashes the LED makes is equal to the fi rst, second and third
digits of the three-digit number respectively.
Press and hold the SET button and, while doing so, press a number
button (1-2-3) to fi nd out the values of the various digits. Then
release both buttons and count the fl ashes.
Summary of Contents for home URC 11T
Page 43: ......
