4
25. The actual instruction manual can be downloaded from www.somogyi.hu website..
26. We don’t take the responsibility for printing errors which may occur, and apologize for them.
In the event that the power cable should become damaged, it should only be replaced with cables
obtained from the manufacturer or its service facility. the manufacturer, its service facility or similarly
qualified personnel.
ASSEMBLY AND COMMISSIONING OF THE DEVICE
Follow the steps shown on
Figure 2. a)
.
1. Remove the bamboo cover from the water tank.
2. Connect the adapter connector to the device.
3. Set the device on a solid, level and flat surface.
4. Fill the water tank with distilled water up to the MAX line. Avoid overfilling the tank, otherwise the
amount of cold vapour produced will be insufficient. Avoid getting water into the fan nozzle (6).
5. At this point, 5-10 drops of quality, natural essential oil can be added to the water as desired. Do
not use artificial substances, as they can cause damage to the device.
6. Replace the bamboo cover.
7. Connect the adapter to a standard 230 V~/50Hz earth protected wall socket.
8. Now the unit is ready for operation!
CLEANING
If hard water is used, over time limescale will be deposited in the water tank and in the parts in contact
with the water. The limescale deposited on the oscillator inhibits normal operation.
We recommend that
1. Use distilled water.
2. Clean the water tank and oscillator weekly.
3. Frequently change the water.
4. If it is not used for a long time, clean the entire appliance and store it dry.
Cleaning the water tank, descaling
1. Turn off the humidifier, then discontinue the power supply by unplugging the connection plug.
2. With slightly vinegar water (1 tablespoonful of vinegar in 1 cup of water), rinse the water tank and
then with clean water.
Cleaning the oscillator, descaling
1. Turn off the humidifier, then disconnect from the power supply by unplugging the connection plug.
2. Drop 5-10 drops of vinegar into the oscillator, wait 2 to 5 minutes
3. Apply with soft material, e.g. clean the oscillator surface with a cleaner.
4. Rinse with clean water.
