4
SOLAR PANEL LED FLOODLIGHT
Before using the product for the first time, please read the instructions for use below and retain them for later
reference. The original instructions were written in the Hungarian language.
This weather resistant, LED floodlight with motion sensor is perfect for illuminating buildings or yards. Solar
powered design, it can be installed independently from mains power.
INSTALLATION, USE
1. Decide where you want to mount the motion sensor floodlight and the solar panel. Ideally, the solar panel
must be exposed to direct sunlight. The product can be adjusted upwards by 20 ° and downwards by 10 °.
2. Solar panel can fixed on wall, can be pinned to or attached to the end of a rod or pole. You can set the ideal
tilt angle when sunlight falls perpendicular to the solar panel.
3. Use the scrolling disc on the side of the solar panel to release and tighten the bracket so that you can adjust
its angle and the secure it.
4. Use the included Allen key to loosen and tighten the screws on the side of the appliance so that you can adjust
the angle of the bracket and then secure it.
5. The concrete anchor supplied with the product allows only fixing on concrete surface. If you want to fix the
product on a different surface, use the appropriate screws and dowels.
6. Use the supplied U-shaped fasteners for mounting on a pole (max Ø60mm). As shown in Figure 2.
7. For mounting on the end of a curved pole (min Ø40mm, max Ø50mm) remove the support bracket as shown
in Figure 3, mount the accessory curved element, and secure the LED floodlight to the end of the pole with it.
8. You can switch the product on using the main switch under the LED panel, next to the PIR sensor.
9. After switching on, the product automatically adjusts its operation, no further intervention is required. It
automatically switches on at 100% brightness for the first 5 hours when motion is detected (max. 8m), then if it
is not detected again for 20 seconds, it decreases the brightness. After 5 hours or if the battery capacity drops
below 30%, it automatically switches on at 100% brightness when motion is detected (max. 8m), then if it is
not detected again for 20 seconds, it decreases the brightness and switches off after 5 minutes.
10. The PIR motion sensor detects a cone of 120°, up to 8 m distance.
CLEANING, MAINTENANCE
In order to ensure the optimum functioning of the luminaire, the unit may require cleaning at least once a month,
depending on the manner of use and degree of contamination. Clean the outer surface of the luminaire and the
solar panel with a slightly moistened cloth. Do not use aggressive cleaners! Avoid getting water inside of and on
the electric components of the appliance.
SPECIFICATIONS
Output:
15 W
Brightness:
1600 lm
Color temperature:
6000 K
Operating temperature:
-15 - +50 °C
IP65 meaning: Protected against dust intrusion. Protected against water jets (from all directions).
Motion sensor type:
PIR
Detection angle:
120°
Detection distance:
max. 8 m
Dimensions:
49,2 x 23,2 x 5,8 cm
Weight:
3,4 kg
