25
EN -Functions / H - Funkciók / SK - Funkcie / RO - Funcţii / SRB-MNE - Funkcije / CZ - Funkce /
HR-BIH - Funkcije
FREE STANDING CERAMIC HEATER
FEATURES
Ceramic fan heater for heating indoor air ● 1000 W / 2000 W output ● modes: cold, warm, hot air ● can be controlled with touch buttons
or remote control ● selectable thermostat values of 18-21-24-27 °C ● shut-off timer for 15 hours ● optional oscillation ● protection
against overheating ● switch-off in case of tipping over
OPERATION
You can turn the appliance on using the on/off switch (4, 13).
Each time the appliance turns on, it starts to operate at the low heating stage. Use the oscillation switch button (10, 17) to turn the
oscillation on or off.
Use the ES button (16) on the remote control to switch the night mode on or off. In this mode, the LED operation indicator of the device
lights up at a lower brightness, while all other indicators turn off.
Heating stage/thermostat value adjustment
Use the heating stage/thermostat adjustment button (5, 14) to set the desired stage or thermostat value. By repeatedly pressing the
button you can select from the following:
● fan mode
● low heating stage
● high heating stage
● 18°C thermostat value
● 21°C thermostat value
● 24°C thermostat value
● 27°C thermostat value
If a thermostat value is set, the unit automatically switches to the appropriate heating stage or the fan mode, when the set value is
reached.
Shut-off timer
Use the shut-off timer setting button (8, 15) to set the shut-off timer. If you press the button again, the LEDs indicating the set time will
illuminate on the appliance. In all cases, the duration of the set timing equals the sum of the clock values indicated by the illuminated
LEDs (i.e., 1h + 2h + 4h
7 hours set value).
Overheating protection
serves to switch off the device in the event of overheating, e.g., if the air inlet or outlet is blocked. Disconnect
the device by pulling out the mains plug. Let the device cool down (min. 30 minutes). Check if the air inlet and outlet are unblocked;
clean them if necessary. Turn on the device again. If the overheat protection keeps activating, disconnect the device by pulling out the
mains plug and contact an authorised service shop.
The appliance turns off automatically if it tips over. In this case, disconnect the appliance by pulling out its mains plug, place it upright
on its stand and then put it back into operation as described in the COMMISSIONING section.
TECHNICALSPECIFICATION
power supply: ....................................................230V/50Hz
output:................................................................
1000 / 2000 W
IP protection: .....................................................IP20: The device is not protected against ingress of water.
heater dimensions: ............................................23 x 64 x 23 cm
weight: ...............................................................2.5 kg
mains cable length: ............................................1.3 m
sound level: .......................................................56 dB(A)
