page 6/15 KKEW9LC05-A/0-20160901
1
2
/
/
/
/
4
3
/
/
/
/
/
Menu Operation Illustration
Under user menu status
1. Press
SET
key more than 5 seconds to enter user menu; if the user password is set, it will pop up the password input box, enter the correct
password to enter the user menu, and then set the parameters.
2. If the current display is the first class, press
SET
key to enter next class display. Press to change other parameters.
3. If the current display is second or third class , press
ESC
key to return to previous class display.
4. If the current display is third class , press key to flash digit, press key to shift place. Keep pressing to change value . Press
SET
key to save value. If press
ESC
key, do not save the set value and return to second class.
5. After modifying the parameters , press
SET
key more than 5 seconds or press
ESC
key, to exit user menu, return to measuring status.
Menu Structure and Function Description
No.
class 1
class 2
class 3
description
System
Setting
Clear Energy
User password
backlight
delay time
page shift time
software version
Input net
Volt transform
Volt transform
Current
transform
Current
transform
signal input
Communication
parameter
Switch signal
setting
Address
baud rate
Data sequence
Alarm mode
Alarm unit
Alarm value
Alarm hysteresis
value
alarm relay
setting
alarm start
delay
alarm finish
delay
Alarm mode
Alarm unit
Alarm value
Alarm hysteresis
value
alarm relay
setting
alarm start
delay
alarm finish
delay
Input “ 1111” to clear energy. Input 2222 to clear maximum demand.
input 1234 to reset to factory setting
Change user password
backlight delay time , unit is second . If set as 0 , mean keep on
lighting all the time.
measurement page shift delay time , unit is second . If set as 0, no
page shift.
software version
Select the input network of the measured signal
Primary coil voltage , unit kV
Secondary coil voltage , unit V
Primary coil current , unit A
Secondary coil current ,unit A
meter address range
Baud rate: 4k8 means 4800, 9k6 means 9600
Data sequence: high digit in front or low digit in front
When the value is 0 , it is for remote control mode, otherwise
it is for alarm mode. Please refer to table 1.
1: means international standard unit, K: means 1000 times of
international standard unit, M: means1000000
times of international standard unit.
1st alarm value setting
1st alarm hysteresis value setting
1st alarm relay output setting
alarm start delay time , unit : second
alarm finish delay time , unit : second
When the value is 0 , it is for remote control mode, otherwise
it is for alarm mode. Please refer to table 1.
1: means international standard unit, K: means 1000 times of
international standard unit, M: means1000000
times of international standard unit.
2nd alarm value setting
2nd alarm hysteresis value setting
2nd alarm relay output setting
alarm start delay time , unit : second
alarm finish delay time , unit : second
