![Sommer Cable CARDINAL DVM-HDBT-EX07-R Instructions Manual Download Page 4](http://html1.mh-extra.com/html/sommer-cable/cardinal-dvm-hdbt-ex07-r/cardinal-dvm-hdbt-ex07-r_instructions-manual_1318399004.webp)
Safety
4
Safety
Intended use
The product is an HDBaseT TX/RX Kit using smart CSC (Color Space
Conversion) technology with no latency to enable HDR and 4K/60Hz 4:4:4
video signal extension over HDBaseT.
The product is intended for use in closed buildings.
Intended use also includes compliance with the accident prevention
regulations and the statutory regulations and standards applicable at the place
of use.
Intended use also comprises reading and understanding these instructions, as
well as observing and following all information therein, especially the safety
instructions.
Any other use is not deemed to be intended.
Basic safety instructions
Severe or fatal injuries due to electric shock are possible.
Use only original CARDINAL DVM 24V DC power supplies like DVM-HDBT-
EX07-P to power the units. Void of warranty and potentially expose the user
to dangerous voltages resulting in an electrical shock could happen in case
of using wrong power supplies.
Do not expose the device to water, moisture, or liquids. Possible electric
shock may result as well as failure of the unit to operate.
Preventing material damage
Install the product in a dust-free environment.
Install the product protected against moisture, vapors, splash water and
wetness.
Install the product in a place protected from direct sunlight.
Do not install the product in the immediate vicinity of heat sources.
Use the product at ambient temperatures between 0 °C
and
35 °C.
The transmission distances of HDMI over TP cables are measured using
AWG23/1 CAT6 a cable.
EIA/TIA-568-B termination for TP cables is recommended for better
performance.
Do not use 568A/568B standard mixed TP cable (cross-over cable) because
there are 2 pairs swapped, this will make POE OVER-CURRENT and
damage POE components. Use straight-through TP cable (both RJ45
headers are 568A or 568B standard).
Power up the device after connections of source, sink and CAT cable.
To reduce the interference among the unshielded twisted pairs of wires in
TP cable, do not run HDBaseT / Zone Cat5e/6/6a cabling with or in close